cs2g-cap-proton-vietnam-thiet-bi-do-duong-kinh-cap-proton-ptc-vietnam.png
EXTRUSION CONTROL 
NEXiS® CS2G-CAP Series Extrusion Controller 
Control of insulation extruder to maintain a target insulation capacitance. 
  • Integrates with Proton Products CG Series Capacitance Gauges for insulation capacitance measurement.
  • 2-row, 5-digit, 7-segment LED display.
  • Panel mounted; optional stand-alone enclosure is available
NEXiS®  CS2G-CAP - connector panel view
Introduction 
The Proton Products NEXiS® CS2G-CAP controller is for use on wire insulation extrusion lines.
NEXiS® CS2G-CAP controllers connect to Proton Products InteliSENS®Capacitance Gauges and Speed and Length Gauges for measurement of insulation capacitance and line speed respectively. These measurements are then fed into a PI feedback controller whose fully-isolated and floating output may be used to drive insulation extruders or capstan drives.
Insulation capacitance is thus actively controlled and kept in tolerance by the NEXiS® CS2G-CAP controller.

NEXIS® CS2G-CAP PRODUCTION LINE CONFIGURATION

CS2G-CAP-image-01

Specifications

Screen 2 row, 7 segment, 5 digit display - Upper row 0.8” (20.32mm) high; lower row 0.5” (12.7mm) high
Display resolution 0.1pF/m
Presets Required capacitance Upper tolerance Lower tolerance Capacitance error Control output %
Serial communications RS232 USB CANbus - (for connection to 1× CG Series gauge)
Line speed inputs Analogue Two inputs available for 0 to 10V and 0 to 50V analogue line speed signals; end-user configurable scaling
Pulse Two inputs available for 0 to 3V and 0 to 10V pulsed line speed signals; maximum frequency 250 kHz; end-user configurable scaling
3×Relay contact outputs Function Capacitance gauge OK Upper tolerance exceeded Lower tolerance exceeded
Electrical Maximum voltage 50VDC / 30VAC
Maximum current 500mA
On resistance (@ 100mA) < 0.1Ω
Off resistance > 10 MΩ
Analogue output 1 Function Measured capacitance
Electrical Output voltage range 0V to +10V
Maximum output current 2mA
Resolution 16-bit
Output voltage scaling is end-user configurable
Analogue output 2 Function Capacitance deviation
Electrical Output voltage range -10V to +10V
Maximum output current 2mA
Resolution 16-bit
Output voltage scaling is end-user configurable
Control algorithm Advanced Control Algorithm (ACA)
Specification
Minimum
Typical
Maximum
Units
Weight     2.5 kg
    5.5 lb
Length     230 mm
    9.1 inch
Width     213.1 mm
    8.4 inch
Height     128.5 mm
    5.1 inch
         
Power supply voltage (rms) 84   264 VAC
Power supply frequency 47   440 Hz
Power supply current (rms)     1 A
Power consumption     35 W
         
Ambient temperature 5   45 °C
41   113 °F
Relative humidity @ 38°C / 105°F     90 %
Ingress Protection (IP) rating     IP50 -
         
PI Controller output voltage -10   10 V
PI Controller output current     10 mA
PI Controller output resistance     10 Ω
PI Controller resolution     12 bit