• Digital limit switch with LCD-Display and for DIN-Rail mounting
• For force transducer with 0/4...20mA output  2- and 3-wire
• 2 potential free relay contacts (changer) with status LED
• Freely programmable analog output (0-20 mA)
• Can be programmed via control panel or computer
• Free PC-software to set parameters via RS-232 interface
• Accuracy 0,2 % of the full scale
• Sensor supply 24 VDC, max. 70 mA
• Needed supply energy 20...90 VDC or 48...253 VAC
• Cable break connection
• User friendly and easy to maintain because of pluggable screw type terminals
• Compact design
• Protection Class IP 20

In combination with load cells or force transducers the limit switch EGS80 is utilized in weighing and load control in hoisting devices, cranes and more. Connectable are 2- and 3- wire sensors as well as active sources with 0/4...20 mA-signal. The input monitors cable breaks and short-circuits on the line and the internal sensor supply is 24 VDC with max 70 mA. The outputs are 2 relays, an active 0/4...20 mA power output and a RS-232-interface. The power output is adjustable freely. The measured values are shown on a small LCD display, it is possible to choose between 17 units such as kg, t, N, bar, and so on. Usually the switch is not pre-adjusted and the customer connects it to the force transducer and also adjusts it. Operating and setting parameters is done through the control panel at the front or with help of the free computer program. The software can also be used to create a data file of the parameters. The file can be saved and installed in any EGS80 limit switch. This is very time saving in case that several switches need to be adjusted. Cables with "SUB-D9/25 to TRS connector" or "USB to TRS connector" are available. Those allow to connect the switch to a computer.