Support|
Model |
Phases |
Firing Mode |
Output |
Current Low |
Current High |
Highlights |
|---|---|---|---|---|---|---|
|
Single phase |
Phase angle, Zero cross, Zero Cross Transformer Mode |
AC |
8 |
400 |
MicroFUSION is an ultra-compact high-performance microprocessor-based power controller, available in single or three phase models to control AC loads. |
|
|
Three phase |
Phase angle, Zero cross, Zero Cross Transformer Mode |
AC |
8 |
400 |
MicroFUSION is an ultra-compact high performance digital SCR controller that adapts to the analog environment as well as the digital environment. |
|
|
Single phase |
Phase angle, Zero cross, Zero Cross Transformer Mode |
AC |
8 |
400 |
MicroFUSION is an ultra-compact high performance digital SCR controller that adapts to the analog environment as well as the digital environment. |
|
|
Three phase |
Phase angle |
DC |
60 |
1 400 |
24 - 600 Vac. A microprocessor-based DC SCR controller operating both analog and digital interfaces. A phase angle-fired controller which linearly controls, with respect to the setpoint, the DC voltage, current, or true power applied to an electrical load. Control is achieved by means of a six SCR bridge with freewheeling diode. |
|
|
Three phase |
Phase angle, Zero cross, Burst |
AC |
50 |
1 200 |
24 - 600 Vac. A microprocessor-based SCR controller operating both analog and digital interfaces. A phase angle or zero cross fired SCR controller which linearly controls, with respect to the setpoint, the AC voltage, current, or true power applied to a three phase electrical load. The 3 phase controller can be ordered in either 2 or 3 leg control with 2 leg being limited to zero cross firing. Control is achieved for 3 leg by three pairs of inverse parallel SCRs or in 2 leg by 2 pairs of inverse parallel SCRs. |
|
|
Single phase |
Phase angle |
DC |
45 |
1 080 |
24 - 600 Vac. A microprocessor-based DC SCR controller operating both analog and digital interfaces. A phase angle fired controller which linearly controls, with respect to the setpoint, the DC voltage, current, or true power applied to an electrical load. Control is achieved by means of a half controlled SCR bridge. |
|
|
Single phase |
Phase angle, Zero cross, Burst |
AC |
50 |
1 200 |
24 - 600 Vac. A microprocessor-based SCR controller operating both analog and digital interfaces. A phase angle or zero cross fired controller which linearly controls, with respect to the setpoint, the AC voltage, current, or true power applied to an electrical load. Control is achieved by means of a pair of inverse parallel SCRs. |
|
|
Three phase |
Phase angle, Zero cross, Burst |
AC |
10 |
160 |
24 - 600 Vac. A microprocessor-based SCR controller operating both analog and digital interfaces. Can be ordered in either 2 or 3 leg control with 2 leg being limited to zero cross firing. Output is controlled linearly with respect to command signal and can be set to the average or RMS value of the voltage or current, as well as true instantaneous power or external feedback. |
|
|
Single phase |
Phase angle, Zero cross, Burst |
AC |
10 |
160 |
24 - 600 Vac. A microprocessor-based SCR controller, operating with both analog and digital interfaces. Output is controlled linearly with respect to command signal and can be set to the average or RMS value of the voltage or current, as well as true instantaneous power or external feedback. |
|
|
Three phase |
Phase angle |
DC |
300 |
400 |
120 - 480 Vac. DC SCR Controller. Accepts most commands. High current, three phase DC output. |
|
|
Three phase |
Phase angle |
AC |
50 |
1 000 |
208 - 575 Vac. Three Phase SCR Controller. Higher current ratings than our solid state relay models. Features include: current limiting, over-current trip, shorted SCR detection. |
|
|
Three phase |
Zero cross |
AC |
200 |
750 |
208 - 575 Vac. Three Phase, Zero Cross SCR Controller. Accepts most commands. Features include: Sync-guard, Trans-guard, shorted SCR detection and on-board line fusing for most frame sizes. |
|
|
Three phase |
Zero cross |
AC |
85 |
750 |
208 - 575 Vac. Analog SCR Controller. Accepts most commands. Features include: Sync-guard, Trans-guard, Shorted SCR detection and on-board line fusing for most frame sizes. |
|
|
Three phase |
Zero cross |
AC |
85 |
750 |
208 - 575 Vac. Analog SCR Controller. Accepts most commands. Features include: Sync-guard, Trans-guard and on-board line fusing for most frame sizes. |
|
|
Single phase |
Phase angle |
AC |
50 |
1 000 |
120 to 575 Vac. Analog SCR Controller. Higher current ratings than our solid state relay models. Features include: current limiting, shorted SCR detection, over-current trip, metering outputs, user selectable feedback modes. |
|
|
Single phase |
Phase angle |
AC |
10 |
70 |
120 - 480 Vac. Analog SCR Controllers. Accepts mA commands. |
|
|
Single phase |
Phase angle |
AC |
10 |
70 |
120 - 480 Vac. Analog SCR Controllers. Accepts Vdc and potentiometer commands. |
|
|
Single phase |
Zero cross |
AC |
10 |
70 |
120 - 575 Vac. Analog SCR Controller. Sync-guard™ smoothes out line current draw when multiple controllers are in use. |
|
|
Single phase |
Zero cross |
AC |
10 |
70 |
120 - 575 Vac. Analog SCR Controller. Accepts most commands. |
|
|
Single phase |
Zero cross |
AC |
10 |
70 |
120 - 575 Vac. Analog SCR Controller. Powered off of the 4/20mA loop, so no control transformer is required. |
