dryer.png

Dryer

Drying of Plastics Enhances Quality of Molding.
Moisture content in plastics adversely affects the quality of molding. Excessive moisture in resins leads to products with unacceptable sturdiness, silver streaks and holes. Dryers serve to remove moisture from resins to prevent molding of such defective products. At times, the increase of temperature is used to enhance the plasticity during molding.

MJ5-i

  • Intelligent type

iplas " is the name for a group of intelligent products developed by MATSUI with self-control functionality. Products equipped with " iplas " continuously monitor customer usage and automati- cally operate in the mode that offers maximum energy and resource efficiency. By controlling operation in response to usage characteristics̶for example, whether the system is being used for full capacity production, minimum mode production, or temporary holding of production " iplas " products are able to deliver significant energy and resource savings compared to their conventional counterparts. (Maximam energy saving onparing to the current product could be up to 75%)

1. A maximum energy reduction of 75% has been achieved!

Conventional equipment consumes the same amount of electricity, regardless of the size of the drying load. MJ5-i has achieved energy reduction by using only the most appropriate amount of electricity according to the size of the drying load.

2. Contributes to electricity conservation!

Since MJ5-i has a low exhaust gas temperature, air conditioning load is reduced, leading to further saving of electricity.

3. Shorter material replacement time!

By reducing the cleaning work during material replacement, a shorter time required for replacement is possible.

4. No more filter maintenance!

Load on the filter has been reduced by the standard installation of a cyclone vacuum type filter, greatly decreasing the frequency of filter maintenance. Daily maintenance consists of simply disposing of the resin powder in the dust box. Moreover, MJ5-i is designed so that the dust box can be removed and attached from the front.

5. Easy operation, no “Operations Manual” required

Required information, such as confirmation of individual settings and operation conditions, trouble- shooting, etc, can be uniformly managed by the controller. The touch panel is easy to use.
 

MJ3

  • plas-aid
  • Environmentally friendly products
  • Patented/ patent pending

MJ3 provides stable low dew point dry air of -40℃ and a suction loader on a single platform. 
This floor top device puts its priority on easy maintenance. As there is no need to replace the absorbent material, performance is being maintained like that of first usage.

1.Reliable

Ensures stable drying condition with honeycomb rotor. Independent drying and conveying circuits allows conveyance of materials without affecting drying condition.

2.Saves Energy

Dual hopper structure enhances thermal insulation and hence, helps conserve energy.

3.Compact

Combine dehumidifying dryer and conveyor into a single unit.

4.Easy Maintenance

All filter maintenance can be done from the operating side.

5.Safe

Heater control circuits are equipped with SSR (non-contact relay), which is safer and reduces the need for maintenance.
 

1.Reliable

Uses heat-resistance drying filter (0.3μm/99.97%) to clean heated air just before charged into the hopper. Matsui’s original push gate prevents contamination that occurs due to friction of the gate.

2.Removes dust residue

Matsui’s original Aero Power Hopper conveys while removing dust residue using the current of airflow.

3.Easy Maintenance

The need for maintenance of filter is reduced as dust falls due to its own weight in the cyclone separator. The manual butterfly valve allows maintenance to be carried out even during the drying process.

4.Safe

Heater control circuits are equipped with SSR (non-contact relay), which is safer and reduces the need for maintenance.